Swipe a diagram sideways to see all of it
ETP Plant
Effluent treatment plants for industrial wastewater
Treat industrial effluent to meet discharge norms and enable reuse. Select, supply and support from Arukal Instruments, serving India and Nepal.
Swipe a diagram sideways to see all of it
Effluent treatment plants for industrial wastewater
Treat industrial effluent to meet discharge norms and enable reuse. Select, supply and support from Arukal Instruments, serving India and Nepal.
An effluent treatment plant (ETP) cleans industrial wastewater before it is discharged or reused. It removes solids, oils, colour, metals and organic load so that the treated water meets the norms of the pollution control board.
Every industry has a different effluent, so each ETP is designed from the effluent analysis. Arukal designs and supplies ETPs with equalisation, chemical treatment, clarification, biological treatment and filtration, with dosing and sludge handling.
An equalisation tank evens out flow and strength so the plant sees a steady load.
Coagulant and flocculant bring suspended and colloidal matter together; the clarifier settles it.
Aeration lets bacteria digest dissolved organic matter, measured as COD and BOD.
Filtration, and if needed UF or RO, polish the water. Sludge is dewatered and disposed of.
Process selected from the effluent analysis and pilot data.
Designed to the discharge standards that apply to you.
Add UF and RO to recover water and cut fresh water cost.
Tanks, pumps, dosing, blowers, filters and sludge handling.
PLC-based control and monitoring on request.
Commissioning, operator training and AMC.
Typical values. Values are typical for the product family and given for guidance. Exact figures depend on the make and model supplied; ask us for the data sheet of the specific model.
| Capacity | 5 – 1,000+ KLD (kilolitres per day) |
|---|---|
| Process | Equalisation, chemical treatment, clarifier, biological (ASP / MBBR / SBR), tertiary filtration |
| Inlet COD | up to 5,000 mg/L (higher with anaerobic stage) |
| Treated water | BOD < 30, COD < 250, TSS < 100 mg/L (typical, to local norms) |
| Sludge handling | Filter press or sludge drying beds |
| Tanks | RCC, MS epoxy-coated or FRP |
|---|---|
| Aeration | Blowers with fine-bubble diffusers |
| Dosing | Chemical dosing system with tanks and pumps |
| Controls | Manual or PLC with sensors |
| Size | Capacity | Typical industry | Notes |
|---|---|---|---|
| Small | 5 – 25 KLD | Small food, lab, workshop | Skid or packaged |
| Medium | 25 – 100 KLD | Textile, dairy, pharma | Tank-based, MBBR |
| Large | 100 – 500 KLD | Chemical, paper, distillery | Multi-stage, with tertiary |
| Extra large | 500 – 1,000+ KLD | Large industrial estates | Custom design |
Capacity in kilolitres per day (1 KLD = 1 m³/day). Every ETP is designed to the effluent analysis.
Feed equalised flow at a steady rate. Keep pH and dosing within the set range.
Check chemical dosing daily with jar tests when the effluent changes.
Remove and dewater sludge on schedule so the clarifier works well.
Record pH, COD, BOD and TSS at the outlet to prove compliance.
From your effluent analysis and flow, and where needed trials. Send us the data and we design the process.
Yes, with filtration, UF and RO it can be reused for cooling, washing or process.
Kilolitres per day, equal to cubic metres per day.
We supply sludge thickening and a filter press or drying beds.
Yes. See Annual Maintenance Contract.